#Drivedx 1.5.1 serial drivers#
#Drivedx 1.5.1 serial driver#
#Drivedx 1.5.1 serial Offline#

If you cannot run the AHT, then create a bootable Memtest86 USB drive using Etcher. If you want to check the memory try running the Apple Hardware Test. It is also possible a memory module has become loose. A lot of time on the MBPros the lower memory slot (nearest the bottom case) can become defective after years of pressure being applied to the center of the bottom case which presses again the lower memory. At the time when you ran the EtreCheck report you were not low on memory even though the system was running really slow. I don't know if this means you have defective memory or whether you ran out of free memory. Many of the other crash reports mention memory.

#Drivedx 1.5.1 serial driver#

You may see the display flicker or flash due to the very basic video driver being used.

#Drivedx 1.5.1 serial drivers#

You could try running the laptop in Safe Mode to see if it helps as this will only use the minimal drivers necessary and will disable Startup & Login Items. Does the same thing happen to an external display? There is a way to force the laptop to use the Intel GPU and instructions to do this have been posted multiple times on these forums. The black screen with backlight seems to suggest a GPU issue or an LCD panel issue. Several of the crash reports mention the GPU.

#Drivedx 1.5.1 serial Offline#

Recently failed Self-tests (Short / Full) : 0 (0 / 0)ġ97 Current Pending Sectors Count 0 100% OKġ98 Offline Uncorrectable Sector Count 0 100% OK Warnings (life-span / pre-fail) : 0 (0 / 0) Throughput per operation (Write) : 4.0 KB/Opįailed Indicators (life-span / pre-fail) : 0 (0 / 0)įailing Indicators (life-span / pre-fail) : 0 (0 / 0) Throughput per operation (Read) : 6.6 KB/Op Last Email Report State Change Flags : 0x800 Offline Data Collection capabilities : 0x5b SMART Command Transport (SCT) flags : 0x3d I/O Path : Book Vendor Id / Product Id : 0x1058 / 0x25ee SATA Version : SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Power On Time : 1.674 hours (2 months 9 days 18 hours)ĭriveDx Active Diagnostic Config : WDC HDD config ĪTA Version : ACS-2, ATA8-ACS T13/1699-D revision 4 Report Timestamp (ISO 8601 format) : T15:49:26ĪTA Command Support Tolerance : verypermissive Report Timestamp : 3 novembre 2017 15:49:26 CET